ASTRO WM-3001 Bedienerhandbuch PDF herunterladen (Seite 13)

CHAPTER 3 CONNECTIONS

3.1 Connections

This section describes how to wire the WM-3001.

(1) Connecting the power supply

Connect the power supply to the round camera connector serving as a power supply

connector ( in the rear view). This connector has 4 pins: pin 1 (GND), pin 4 (DC input)

and pins 2 and 3 (no connection). Either the accessory cable (4-pin round camera

connector/cannon connector conversion cable) or the optional (*) DC input cable

(DM-3000A-09) is available for the power supply connector. Check the configuration of

your cable end connector prior to use.

(2) Connecting the source of input signals

When inputting HDTV SDI or SDTV SDI signals, connect the signal source to the SDI

terminal using a BNC coaxial cable. The IN terminal is used to input SDI signals, and the

MONITOR OUT terminal is used to monitor the SDI signals being input. Supply

BTAS-004B or SMPTE 259M compatible serial digital signals to the SDI input terminal.

For SDI signals, use a coaxial cable (5C-FB or equivalent) capable of handling the 1.5 GHz

band.

When inputting HDTV analog signals, connect the sources of Y, Pb and Pr signals to the

ANALOG Y, ANALOG Pb and ANALOG Pr terminals, respectively. Supply BTAS-001B

compatible Y/Pb/Pr signals to the ANALOG input terminal. Synchronization is achieved by

means of the Y signal.

(3) Setting

Use the menu mode to set up input signals and their formats. Also make other settings as

necessary. Do not change the settings of the rear-panel DIP switch unless you need to

change the terminating resistor.

* For details on optional accessories see Chapter 6, Section 6.2, “Optional Accessories.”

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 45 46

Keine Kommentare

ASTRO WM-3001 Bedienerhandbuch Seite 13